Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 532)

500 Network OS NETCONF Operations Guide
53-1003231-02
Configuring RSPAN
32
1
Hello World
source
tengigabitethernet
3/0/15
destination
tengigabitethernet
5/0/18
both
This configuration rule applies to ingress, egress, and both directions of SPAN. Otherwise,
configure SPAN as you would in standalone mode. Refer to
“SPAN configuration with NETCONF
overview” on page 495.
Configuring RSPAN
The principal difference between configuring SPAN and RSPAN is that RSPAN requires a remote
VLAN to be created first. This example demonstrates the configuration of a bidirectional RSPAN.
To create a VLAN interface, perform the following steps.
1. Issue an RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace,
2. Under the element, specify the / hierarchy of node
elements.
3. Under the node, specify the element containing the new VLAN ID.
The following example creates VLAN 1010.
1010