Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 184)

152 Network OS NETCONF Operations Guide
53-1003231-02
Resource monitoring
12
Resource monitoring
For a conceptual overview of resource monitoring, refer to the Network OS Administrator’s Guide.
Configuring memory monitoring
NOTE
E-mail is not a supported action for threshold monitoring.
To configure memory monitoring, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-threshold-monitor namespace.
2. Under the node, include the /
hierarchy of node elements.
3. Under the node, include the following leaf elements to configure memory
monitoring.
a. In the element, specify the time in seconds after which the system monitor will poll
the resource usage. Range is 10 through 3600. Default is 120.
b. In the element, specify the number of retries that the system monitor takes before
triggering an action. Range is 1 through 100. Default is 3.
c. In the element, specify the usage limit as a percentage of available resources.
Range is 0 through 80. Default is 60.
d. In the element, specify the upper usage limit for memory as a percentage of
available memory. Range is 0 through 80. Default is 70.
e. In the element, specify the lower usage limit for memory as a percentage of
available memory. Range is 0 through 80. Default is 40.
f. In the element, specify the action the system monitor triggers when a threshold
is crossed. Specify “raslog” to send a RASlog message, “snmp” to issue an SNMP trap,
“all” to send a RASlog message and issue an SNMP trap, or “none” to do nothing. Default
is none.
The following example configures memory monitoring.
xmlns="urn:brocade.com:mgmt:brocade-threshold-monitor">
30
3
75
80
50
raslog