Configuring the path cost for all xstp – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual
Page 389

Network OS NETCONF Operations Guide
357
53-1003231-02
Configuring all xSTP on DCB interface ports
24
a. In the
port-channel number.
b. In the
port.
c. Include the
urn:brocade.com:mgmt:brocade-xstp namespace.
4. Under the
automatic edge detection on the DCB interface.
operation="delete"/> Configuring the path cost for all xSTP Use this procedure to configure the path cost for spanning tree calculations. The lower the path To configure the path cost for spanning tree calculations on the DCB interface, perform the 1. Issue the urn:brocade.com:mgmt:brocade-interface namespace. 2. Under the 3. Under the a. In the port-channel number. b. In the port.
cost means there is a greater chance of the interface becoming the root port. The range is 1
through 200000000. The default path cost is 2000 for a 10 Gbps interface.
following steps.