Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 80)

48 Network OS NETCONF Operations Guide
53-1003231-02
Time zone settings
4
1. Issue the action located in the urn:brocade.com:mgmt:brocade-clock
namespace.
2. Under the node, specify the < clock> node element.
3. Under the node element, specify the element and provide a value for the
desired date and time in the format CCYY-MM-DDTHH:MM:SS.
The following example sets the local time to 2:15 in the afternoon of May 17, 2012.
2012-05-17T14:15:00
message-id="304">
Time zone settings
You can set the time zone by specifying one of the following regions with a city from that region:
Africa, America, Pacific, Europe, Antarctica, Arctic, Asia, Australia, Atlantic, and Indian. Refer to the
Network OS Administrator’s Guide for a list of accepted time zones for each region.
Setting the time zone
Use the action to set the time zone for a switch. This action is defied in the
urn:brocade.com:mgmt:brocade-clock namespace. You must use this operation for all switches for
which a time zone must be set. However, you must set the time zone only once on each switch
because the value is written to nonvolatile memory.
NOTE
After upgrading your switch firmware, you may need to reconfigure the time zone information.
To set the time zone, in the / node, set the element
to the desired time zone.
The following example sets the time zone for Los Angeles, California.
America/Los_Angeles