Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 377)

Network OS NETCONF Operations Guide 345
53-1003231-02
Spanning tree configuration and management
24
2*(forward_delay - 1)>=max_age>=2*(hello_time + 1)
To specify the bridge maximum aging time for a VLAN, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the , or node element.
4. Under the , or node, include the node element.
5. Under the node, include the following leaf elements.
a. In the element, specify the VLAN ID.
b. In the leaf element, specify the bridge maximum aging limit for the specified
VLAN.
200
25
Enabling the error disable timeout timer for all xSTP
For any spanning tree mode (STP, RSTP, MSTP, PVST, or Rapid PVST), use this procedure to enable
the timer to bring a port out of the disabled state. When the STP BPDU guard disables a port, the
port remains in the disabled state unless the port is enabled manually. The
node allows you to enable the port from the disabled state. For details on
configuring the error disable timeout interval, refer to
“Specifying the error disable timeout interval
for all xSTP” on page 346.
By default, the timeout feature is disabled.
To enable the error disable timeout timer, perform the following steps.