Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 243)

Network OS NETCONF Operations Guide 211
53-1003231-02
TACACS+ accounting
16
Configuring the client to use TACACS+ for login authentication
After configuring the client-side TACACS+ server list, you must set the authentication mode so that
TACACS+ is used as the primary source of authentication. Refer to
“Login authentication mode” on
page 198 for information on how to configure the login authentication mode.
TACACS+ accounting
This section provides procedures and examples for configuring TACACS+ accounting on the client.
For related conceptual information, limitations, information about viewing TACACS+ accounting
logs, and firmware downgrade considerations, refer to the Network OS Administrator’s Guide.
Enabling login accounting
The following procedure enables login accounting on a switch where accounting is disabled.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-aaa namespace.
2. Under the node, include the
//// hierarchy of node elements.
3. Under the node, include the element and specify tacacs+ as the
server type.
tacacs+