Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 373)

Network OS NETCONF Operations Guide 341
53-1003231-02
Spanning tree configuration and management
24
20480
Specifying the bridge priority on a per-VLAN basis
Using PRVT or Rapid-PVST, you may specify the bridge-priority for a specific VLAN. If the VLAN
parameter is not provided, the priority value is applied globally for all per-VLAN instances. But for
the VLANs which have been configured explicitly, the per-VLAN configuration takes precedence over
the global configuration.
The VLAN ID value can be 1 through 3583. VLAN IDs 3584 through 4094 are internally-reserved
VLAN IDs.
To specify a bridge priority for a specific VLAN, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the , or node element.
4. Under the , or node, include the node element.
5. Under the node element, include the following leaf elements.
a. In the element, specify the VLAN ID.
b. In the element, specify the bridge priority.
100
20480