Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 480)

448 Network OS NETCONF Operations Guide
53-1003231-02
Congestion control
29
Enabling a RED profile to use CoS priority
To map a CoS priority value on a per-port basis to the RED profile created under “Configuring RED
profiles” on page 447, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include a node element to specify the interface type;
, , , ,
or .
3. Under the node element designating the interface type, include the leaf element and
specify the name of the interface on which you want to enable a RED profile.
4. Under the node element designating the interface type, include the node element,
which is located in the urn:brocade.com:mgmt:brocade-qos namespace.
5. Under the node, include the / hierarchy of node elements.
6. Under the node element, include the following leaf elements.
a. In the element, specify the CoS priority.
b. In the element, specify the ID of the RED profile you want to apply.
7. Issue the RPC to save the running-config file to the startup-config file.
The following example applies CoS priority 3 on port 22/0/2 to RED profile 10.
22/0/2
3
10
Ethernet Pause
This section provides procedures for configuring Ethernet Pause congestion control.