Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 418)

386 Network OS NETCONF Operations Guide
53-1003231-02
LACP configuration and management
26
25000
Configuring the LACP timeout period on a DCB interface
The LACP timeout period indicates how long LACP waits before timing out the neighboring device.
The short timeout period is 3 seconds and the long timeout period is 90 seconds. The default is
long.
To configure the LACP timeout period on a DCB interface, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, specify the , ,
, or node element.
3. Under the , , , or
node, specify the element and set its value to the interface
name in [rbridge-id/]slot/port format.
4. Under the , , , or
node, specify the node, which resides in the
urn:brocade.com:mgmt:brocade-lacp namespace.
5. Under the node, specify the leaf element and set its value to either “short”
or “long”.
The following example sets the LACP timeout period to three seconds for the 1/0/1 interface.
1/0/1
short