Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 417)

Network OS NETCONF Operations Guide 385
53-1003231-02
LACP configuration and management
26
3. Under the , , , or
node, specify the following elements:
a. In the element, provide the name of the interface you want to add to the LAG.
b. In the element, include the delete operation in the element tag to enable the
interface.
c. Include the node element.
4. Under the node, specify the following elements to configure the LACP for the
DCB interface:
a. In the element, provide value to the channel group number.
b. In the element, specify “active” or “passive”
c. In the element, specify “standard” or “brocade”.
The following example adds port 8/0/1 to channel group 4 in active mode, standard type.
8/0/1
operation="delete"/>
4
active
standard
Configuring the LACP system priority
Configure an LACP system priority on each switch running LACP. LACP uses the system priority with
the switch MAC address to form the system ID and also during negotiation with other switches.
The system priority value must be a number in the range of 1 through 65535. The higher the
number, the lower the priority. The default priority is 32768.
To configure the global LACP system priority, issue the RPC to configure the
node in the urn:brocade.com:mgmt:brocade-lacp namespace and provide a value in the
leaf element.