Configuring iscsi priority, Configuring lldp profiles – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual
Page 430

398
Network OS NETCONF Operations Guide
53-1003231-02
Configuring LLDP global options
27
Configuring iSCSI priority
The iSCSI priority setting is used to configure the priority that will be advertised in the DCBX iSCSI
TLV.
The iSCSI TLV is used only to advertise the iSCSI traffic configuration parameters to the attached
CEE-enabled servers and targets. No verification or enforcement of the usage of the advertised
parameters by the iSCSI server or target is done by the switch. The default iSCSI priority is 4. The
valid range is 0 through 7.
To configure the iSCSI priority, perform the following steps.
1. Issue the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the
urn:brocade.com:mgmt:brocade-lldp namespace.
3. Under the
desired priority.
4. Under the
5. Under the
The following example sets the iSCSI priority to 4 and advertises this value in the DCBX iSCSI TLV.
Configuring LLDP profiles
You can configure up to 384 profiles on a switch.
To configure an LLDP profile, perform the following steps.