Verifying cos-to-cos mutation qos mapping – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual
Page 458

426
Network OS NETCONF Operations Guide
53-1003231-02
Queueing
29
5. Under the
mutation QoS map to activate and apply changes made to the map.
6. Under the
7. Under the
trust mode for incoming traffic.
This step specifies the interface ingress QoS trust mode, which controls user priority mapping
of incoming traffic. The untrusted mode overrides all incoming priority markings with the
Interface Default CoS. The CoS mode sets the user priority based on the incoming CoS value. If
the incoming packet is not priority tagged, then fallback is to the interface default CoS value.
8. Issue the
The following example activates a map named “test” on 10-gigabit interface 22/0/2, and
establishes trust mode.
Verifying CoS-to-CoS mutation QoS mapping
To verify a CoS-to-CoS mutation mapping, issue the
mutation QoS map and the interface names to which a map is bound.
1. Verify a CoS-to-CoS mutation QoS map using a subtree filter to view only the contents of the
The following example returns the CoS-to-CoS mutation QoS map for a map named “test.”