Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 397)

Network OS NETCONF Operations Guide 365
53-1003231-02
Configuring all xSTP on DCB interface ports
24
5
Specifying a link type
Use this procedure to specify a link type. Specifying a point-to-point link type enables rapid
spanning tree transitions to the forwarding state. Specifying the shared link type disables spanning
tree rapid transitions. The default setting is point-to-point.
To specify a link type on a DCB interface, perform the following steps.
1. Issue the RPC to configure the interface node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the , ,
, , or node element.
3. Under the , , ,
, or node element, include the following elements.
a. In the element, specify the interface name in [rbridge-id/]slot/port format or
port-channel number.
b. In the element, include the delete operation in the element tag to enable the
port.
c. Include the node, which resides in the
urn:brocade.com:mgmt:brocade-xstp namespace.
4. Under the node element, include the leaf element and specify a
value of “point-to-point” or “shared”.
22/0/1
operation="delete"/>
shared