Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 60)

28 Network OS NETCONF Operations Guide
53-1003231-02
Interfaces, slots, and modules
3
To perform a reboot of the entire modular chassis, issue the / custom action
located in the urn:brocade.com:mgmt:brocade-ha namespace.
To perform a fastboot operation, issue the / custom action located in the
urn:brocade.com:mgmt:brocade-firmware namespace.
NOTE
Both reboot operations are disruptive, and you are prompted for confirmation before executing.
When you reboot a switch connected to a fabric, all traffic to and from that switch stops. All ports on
that switch remain inactive until the switch comes back online.
Interfaces, slots, and modules
This section describes a few frequently used or important operations performed on slots, modules,
or interfaces. Refer to the Network OS Administrator’s Guide for an extensive overview of modular
platform basics.
Obtaining interface configuration information
To obtain interface information, issue the RPC with a subtree filter to return only
information under the node located in the urn:brocade.com:mgmt:brocade-interface
namespace.
The following example further restricts the output to 10 Gigabit Ethernet interfaces by specifying
the node in the subtree filter.