Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 335)

Network OS NETCONF Operations Guide 303
53-1003231-02
Chapter
22
Configuring VXLANs
In this chapter
• VXLAN configuration with NETCONF overview . . . . . . . . . . . . . . . . . . . . . . . 303
• VXLAN configuration and management . . . . . . . . . . . . . . . . . . . . . . . . . . . . 303
VXLAN configuration with NETCONF overview
This chapter provides procedures for configuring VXLANs using the NETCONF interface. Refer to the
Network OS Administrator’s Guide for the following related information:
• An overview of VXLANs
• An explanation of how VXLAN tunnel endpoints work
• Conceptual information about high-level communication in a VXLAN environment
• VXLAN configuration guidelines and restrictions
• Information to provide to virtual network administrators
• Scaling information
Through the NETCONF interface, you can perform the following operations on VXLANs:
• Use the RPC to configure VXLANs and NSX controllers.
• Use the RPC to validate configuration settings.
VXLAN parameters are defined in the brocade-interface and brocade-VXLAN YANG modules. For
structural maps of these YANG modules, refer to the Network OS YANG Reference Manual. For
definitions and explanations of all VCS Fabric management parameters, refer to the
brocade-interface.yang, and brocade-VXLAN.yang files.
VXLAN configuration and management
NOTE
Use the RPC to save your configuration changes.