Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 316)

284 Network OS NETCONF Operations Guide
53-1003231-02
VLAN configuration and management
21
xmlns="urn:brocade.com:mgmt:brocade-interface">67174401
2500
2500
up
up
(output truncated)
Configuring an interface port as an access interface
Each DCB interface port supports admission policies based on whether the frames are untagged or
tagged. Access mode admits only untagged and priority-tagged frames.
To configure the interface as an access interface requires two RPCs. The first RPC configures the
port as a Layer 2 interface; the second RPC configures the interface port as an access interface.
1. Issue an RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, specify the interface type element (,
, , or ).
3. Under the , , , or
element, include the following elements:
a. In the element, specify the port name in [rbridge-id/]slot/port format.
b. Include the / elements to configure the port as a Layer 2 interface.
The following example configures 10-Gigabit Ethernet port 1/0/1 as an access interface port.
1/0/1
4. Issue another RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
5. Under the node, specify the same interface type you specified in step 2 ; that is,
, , , or
.