Configuring a new port-profile – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual
Page 274

242
Network OS NETCONF Operations Guide
53-1003231-02
Configuring AMPP port-profiles
19
Configuring a new port-profile
To support VM MAC address learning, the default port-profile is employed. The default profile is
different from the other user-defined AMPP profiles:
•
The port-profile ID (ppid) of the profile cannot be changed.
•
The VLAN subprofile cannot be modified.
•
The QoS subprofile and security-profile cannot be added.
•
The default port-profile cannot be activated.
•
When there are no port-profile-ports in the system, the default port-profile can be added with
the FCoE profile.
Brocade recommends that you create a new port-profile to accommodate your requirements. To
configure a new port-profile, perform the following steps. The following steps create and activate a
port-profile and associate it with the MAC address of each host.
1. Configure the physical interface before creating the port-profile.
2. Put the port under "port-profile-port" mode, using the
brocade-interface.yang
3. Create the
4. Create the VLAN subprofile under the
5. Under the VLAN subprofile, configure the
attributes.
6. Issue an
This step configures the
namespace.