Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 442)

410 Network OS NETCONF Operations Guide
53-1003231-02
ACL configuration and management
28
test_02
in
Applying a MAC ACL to a VLAN interface
Ensure that the ACL that you want to apply exists and is configured to filter traffic in the manner
that you need for a specific VLAN interface. An ACL does not take effect until it is expressly applied
to an interface. Frames can be filtered as they enter an interface (ingress direction).
To apply a MAC ACL to a VLAN interface, perform the following steps.
1. Issue an RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, specify the / hierarchy of node elements.
3. Under the node, include the element and specify the VLAN-ID of the VLAN to
which you want to assign an access list.
4. Under the node, specify the node that resides in the
urn:brocade.com:mgmt:brocade-mac-access-list namespace.
5. Under the node, include the node element.
6. Under the node, include the leaf element, and set its value
to the name of the MAC access list you want to apply to the VLAN.
7. Optional: Under the node, include the leaf element, and set
its value to “in” or “out” to associate the ACL with ingress traffic or egress traffic, respectively.
50
list">