Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 165)

Network OS NETCONF Operations Guide 133
53-1003231-02
Chapter
11
Configuring Fibre Channel Ports
In this chapter
• Fibre Channel ports configuration with NETCONF overview. . . . . . . . . . . . 133
• Fibre Channel port attributes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134
• Retrieving the Fibre Channel port configuration . . . . . . . . . . . . . . . . . . . . . 134
• Fibre Channel port activation and deactivation . . . . . . . . . . . . . . . . . . . . . 136
• Setting Fibre Channel port speed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 137
• Configuring a Fibre Channel port for long distance operation . . . . . . . . . . 138
• Configuring a Fibre Channel port for trunking . . . . . . . . . . . . . . . . . . . . . . . 139
• Retrieving Fibre Channel interface information . . . . . . . . . . . . . . . . . . . . . 140
Fibre Channel ports configuration with NETCONF overview
This chapter provides procedures for configuring Fibre Channel ports using the NETCONF interface.
Refer to the Network OS Administrator’s Guide for related conceptual and overview information.
Through the NETCONF interface, you can perform the following operations on Fibre Channel ports:
• Use the RPC to activate and deactivate a Fibre Channel port and set the following
port attributes:
- desire-distance
- fill-word
- isl-r_rdy
- long-distance
- speed
- trunk-enable
- vc-link-init
• Use the RPC to view all or part of the Fibre Channel port configuration.
• Use the custom RPC to return operational information about
the interface.
Fibre Channel port parameters are defined in the brocade-interface YANG module. The
RPC is defined in the brocade-fabric-service YANG module. For
information about these YANG modules, refer to the Network OS YANG Reference Manual.