Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 327)

Network OS NETCONF Operations Guide 295
53-1003231-02
Configuring protocol-based VLAN classifier rules
21
up
up
(output truncated)
Obtaining port information for a sequence of ports
To retrieve information for a sequence ports, issue the RPC multiple times
and use the node element on input.
Before issuing the RPC, check the output of the previous invocation to
determine whether the boolean element is set to “true”. If so, information is available
for additional interfaces; proceed as follows:
1. Issue the RPC in the urn:brocade.com:mgmt:brocade-interface-ext
namespace.
2. Under the node, include the node element.
3. Under the node, include the following leaf elements.
a. In the element in the urn:brocade.com:mgmt:brocade-interface
namespace, specify the interface type—For example “tengigabitethernet”.
b. In the element from theurn:brocade.com:mgmt:brocade-interface
namespace, specify the port name in the [rbridge-id/]slot/port format of the port for which
information was returned in the last invocation of the RPC.
The RPC returns information about the next port.
4. Check the element in the output to determine whether information is available for
additional port interfaces.
5. Repeat the procedure until the element returns “false”.
tengigabitethernet
1/0/1
rpc-reply message-id="1921" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
tengigabitethernet
1/0/1
67174401
2500
2500
up
up
(output truncated)
true