Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 317)

Network OS NETCONF Operations Guide 285
53-1003231-02
VLAN configuration and management
21
6. Under the , , , or
element, include the following elements:
a. In the element, specify the same port name you specified in step 3 .
b. Include the / hierarchy of node elements.
7. Under the node element, specify the leaf element containing the
VLAN ID to configure a layer 2 switch port as an access interface.
22/0/1
20
Configuring an interface port as a trunk interface
Each DCB interface port supports admission policies based on whether the frames are untagged or
tagged. Trunk mode admits only VLAN-tagged frames.
This procedure performs the following functions:
• Enables the interface.
• Specifies trunk mode.
• Specifies whether one, all, or none of the VLAN interfaces are allowed to transmit and receive
through the DCB interface.
To configure the interface as a trunk interface requires two RPCs. The first RPC configures the port
as a Layer 2 interface; the second RPC configures the interface port as a trunk interface.
1. Issue an RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, specify the interface type element (,
, , or ).
3. Under the , , , or
element, include the following elements: