Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 463)

Network OS NETCONF Operations Guide 431
53-1003231-02
Queueing
29
19
12,14,16,18
20
2,4,6,8
10
Applying a DSCP mutation map to an interface
To apply a DSCP mutation QoS map, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include a node element to specify the interface type;
, , , ,
or .
3. Under the node element designating the interface type, include the leaf element and
specify the name of the interface to which you want to apply the map.
4. Under the node element designating the interface type, include the node element,
which is located in the urn:brocade.com:mgmt:brocade-qos namespace.
5. Under the node, include the leaf element and specify the DSCP
mutation QoS map to activate and apply changes made to the map.
6. Under the node, include the node element.
7. Under the node element, include the empty leaf element to specify the
trust mode for incoming traffic.
8. Issue the RPC to save the running-config file to the startup-config file.
The following example activates a map named “test” on 10-gigabit interface 22/0/2, and
establishes DSCP trust mode.
22/0/2