Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 395)

Network OS NETCONF Operations Guide 363
53-1003231-02
Configuring all xSTP on DCB interface ports
24
100
Specifying the MSTP hello time
Use this procedure to set the time interval between BPDUs sent by the root switch. Changing the
hello time affects all spanning tree instances.
The setting must be greater than the setting (refer to “Specifying the
bridge maximum aging time for all xSTP” on page 344). The range is 1 through 10 seconds. The
default is 2 seconds.
To specify the MSTP hello time on a DCB interface, perform the following steps.
1. Issue the RPC to configure the interface node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the , ,
, , or node element.
3. Under the , , ,
, or node element, include the following elements.
a. In the element, specify the interface name in [rbridge-id/]slot/port format or
port-channel number.
b. In the element, include the delete operation in the element tag to enable the
port.
c. Include the node element, which resides in the
urn:brocade.com:mgmt:brocade-xstp namespace.
4. Under the node, include the leaf element and specify the hello
time on the DCB interface.
22/0/1