beautypg.com

Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 593

background image

Network OS NETCONF Operations Guide

561

53-1003231-02

Configuring BGP

37

default-metric—Set metric of redistributed routes

maximum-paths—Forward packets over multiple paths

multipath—Enable multipath for iBGP or EBGP neighbors only

neighbor—Specify a neighbor router

network—Specify a network to announce via BGP

next-hop-enable-default—Enable default route for BGP next-hop lookup

next-hop-recursion—Perform next-hop recursive lookup for BGP route

redistribute—Redistribute information from another routing protocol

rib-route-limit—Limit BGP rib count in routing table

static-network—Special network that do not depends on IGP and always treat as best route in
BGP

table-map—Map external entry attributes into routing table

update-time—Configure IGP route update interval

For complete information on all of these nodes, refer to the BGP parameters are defined in the
brocade-bgp YANG module. For information about the brocade-bgp YANG module, refer to the
Network OS YANG Reference Manual.

This configuration example configures the neighbor with a weight of 20.

1. Issue the RPC to configure the node in the

urn:brocade.com:mgmt:brocade-bgp namespace.

2. Under the node, open the node.

3. Under the node, open the node.

4. Under the node, open the node.

5. Under the node, open the node.

6. Under the node, configure the nodes for IPv4 unicast address configuration.

188

default

1.1.1.1

20