beautypg.com

Enabling vrrp for vrf – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 588

background image

556

Network OS NETCONF Operations Guide

53-1003231-02

Configuring VRF

36

4. Configure the static ARP for the interface. The static route and ARP must be configured under

address family mode.

3.3.3.3

4.4.4

interface

2/0/9

The following example configures all commands under the VRF submode. This configuration is
non-default VRF.

red

10:1

1200

44.4.4.4/32

default-vrf

2.2.2.2

3.3.3.3

4.4.4

interface

2/0/9

6.7.8.9

Enabling VRRP for VRF

To enable the Virtual Router Redundancy Protocol (VRRP) or VRRP-Extended (VRRP-E) for a Virtual
Routing and Forwarding (VRF) region, an interface should be assigned to a VRF region before
enabling VRRP or VRRP-E. VRRP is enabled or disabled globally on the switch under RBridge ID
configuration mode; it cannot be enabled or disabled on a specific VRF instance. For more
information on VRRP on Brocade switches, refer to

Chapter 35, “Configuring VRRP”

.