Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 169)

Network OS NETCONF Operations Guide 137
53-1003231-02
Setting Fibre Channel port speed
11
Disabling a Fibre Channel port
To disable a Fibre Channel port, add the element to the instance using the
RPC.
Perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node element.
3. Under the node element, include the following leaf elements.
a. In the element, identify the port you want to disable. Identify the port by
rbridge-ID/slot/port.
b. Specify the element with no value.
The following example disables port 1 on routing bridge 8.
8/0/1
Setting Fibre Channel port speed
This procedure sets the port speed to 1, 2, 4, or 8 Gbps, or to autonegotiate (the default value).
To set the speed of a Fibre Channel port, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.comn:mgmt:brocade-interface namespace.
2. Under the node, include the node element.
3. Under the node element, include the following leaf elements.
a. In the element, identify the port you want to configure in rbridge-ID/slot/port
format.
This element specifies the instance of the node.