Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 195)

Network OS NETCONF Operations Guide 163
53-1003231-02
Chapter
13
VMware vCenter
In this chapter
• vCenter management with NETCONF overview. . . . . . . . . . . . . . . . . . . . . . 163
• Configuring vCenter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 163
vCenter management with NETCONF overview
This chapter provides procedures and examples for Brocade VCS Fabric management using the
NETCONF interface. Refer to the Network OS Administrator’s Guide for the following related
information:
• A conceptual overview of concepts related to Brocade vCenter technology
• Brocade vCenter guidelines and restrictions
• Brocade vCenter discovery principles
• How to perform Brocade vCenter management using the Network OS command line interface
(CLI)
Using the NETCONF interface, you can perform the following vCenter configuration operations:
• Use the remote procedure call (RPC) to perform the following operations:
- Enable and disable vCenter
- Configure discovery time interval
- Configure user-triggered vCenter discovery
• Use the RPC to verify all or part of the vCenter configuration.
• Use the custom RPC to return configuration state information about vCenter.
Brocade vCenter parameters are defined in the brocade-vswitch YANG module. For structural maps
of this YANG module, refer to the Network OS YANG Reference Manual.
Configuring vCenter
The processes in this section configure vCenter.
Step 1: Enabling QoS
You must edit the network resource pool settings and set QoS priorities. Refer to the latest VMware
vSphere Networking documentation.