Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 379)

Network OS NETCONF Operations Guide 347
53-1003231-02
Spanning tree configuration and management
24
5. Under the node, include the element and specify the time
in seconds it takes for an interface to timeout.
60
Specifying the port-channel path cost for all xSTP
For STP, RSTP, MSTP, PVST, or Rapid PVST, use this procedure to specify the port-channel path cost.
The default port cost is standard. The path cost options are:
• custom—Specifies that the path cost changes according to the port-channel’s bandwidth.
• standard—Specifies that the path cost does not change according to the port-channel’s
bandwidth.
To specify the port-channel path cost, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the , , , , or node
element.
4. Under the , , , , or node, include the node
element
5. Under the node, include the leaf element and specify “custom” or
“standard” to specify the port channel path cost.