Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 400)

368 Network OS NETCONF Operations Guide
53-1003231-02
Configuring all xSTP on DCB interface ports
24
22/0/1
operation="delete"/>
32
Specifying the port priority per VLAN (PVST and Rapid PVST)
Use this procedure to specify the port priority on a per VLAN basis. The range is 0 through 240 in
increments of 16. The default is 128. A lower number designates a higher priority. For the VLANs
which have been configured explicitly, the per-VLAN configuration takes precedence over the global
configuration.
The VLAN ID value can be 1 through 3583. VLAN IDs 3584 through 4094 are internally-reserved
VLAN IDs.
To specify the port priority on the DCB interface for a specific VLAN, perform the following steps.
1. Issue the RPC to configure the interface node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the , ,
, , or node element.
3. Under the , , ,
, or node element, include the following elements.
a. In the element, specify the interface name in [rbridge-id/]slot/port format or
port-channel number.
b. In the element, include the delete operation in the element tag to enable the
port.
c. Include the node element, which resides in the
urn:brocade.com:mgmt:brocade-xstp namespace.
4. Under the node, include the node element.
5. Under the node element, include the following leaf elements.
a. In the element, specify the VLAN ID.
b. In the element, specify the port priority for the specified VLAN.