Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 50)

18 Network OS NETCONF Operations Guide
53-1003231-02
Editing the configuration
2
xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="209">
1045274
1043895
367
373
1
2011-11-16 16:54:31 GMT-7:00
2011-11-16 16:23:44 GMT-7:0
For a list of available actions and their locations, refer to the Network OS YANG Reference Manual.
Editing the configuration
All configuration editing is done using the merge or delete operations of the RPC. The
create and replace operations are not supported. Refer to RFC 4741, The NETCONF Protocol, for
details about these operations.
NOTE
Every NETCONF request should have a one-to-one mapping with a Brocade command.
You cannot combine two CLI operations into one NETCONF request.
The following example of the default merge operation adds a static address to the MAC address
table. The operation is performed on the running configuration and configures the
node in the urn:brocade.com:mgmt:brocade-mac-address-table namespace.
xmlns="urn:brocade.com:mgmt:brocade-mac-address-table">
0011.2222.3333
forward
tengigabitethernet
66/0/1
vlan
100