Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 364)

332 Network OS NETCONF Operations Guide
53-1003231-02
Configuring RSTP
24
22/0/11
operation="delete"/>
22/0/13
operation="delete"/>
32
When the spanning tree topology is completed, the network switches send and receive data only on
the ports that are part of the spanning tree. Data received on ports that are not part of the
spanning tree is blocked.
NOTE
Brocade recommends leaving other STP variables at their default values.
For more information on STP, refer to “Spanning tree configuration and management” on
page 338.
Configuring RSTP
The basic process for configuring RSTP is as follows.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the node element.
Refer to “Enabling STP, RSTP, MSTP, PVST, or Rapid PVST” on page 338 for details.
4. Under the node, designate the root switch using the leaf node.