Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 322)

290 Network OS NETCONF Operations Guide
53-1003231-02
Configuring protocol-based VLAN classifier rules
21
NOTE
For complete information on all available VLAN classifier rule options, refer to the Network OS
Command Reference.
Configuring a VLAN classifier rule
To configure an ARP-based VLAN classifier rule, perform the following steps.
1. Issue an RPC to configure the node in the
urn:brocade.com:mgmt:brocade-vlan namespace.
2. Under the node, include the / hierarchy of node elements.
3. Under the node, include the element, and set it to an integer representing the
rule ID.
4. Under the element, specify the node element.
5. Under the node element, include the leaf element and set its value to
“arp” to specify ARP.
6. Under the node element, include the element and set its value to “ethv2”.
5
arp
ethv2
NOTE
Refer to the Network OS Command Reference for complete information on all the protocols available
for specifying VLAN classifier rules.
Configuring MAC address-based VLAN classifier rules
To configure a MAC address-based VLAN classifier rule, perform the following steps.