beautypg.com

Setting the snmp version 3 host – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 110

background image

78

Network OS NETCONF Operations Guide

53-1003231-02

SNMP server hosts

7

1050:0:0:0:5:600:300c:326b

commaccess

162

Setting the SNMP version 3 host

Setting the SNMP version 3 server host sets the trap destination IP addresses, user name,
notification type, destination port, and engine ID for the SNMP server host.

1. Issue the RPC to configure the node in the

urn:brocade.com:mgmt:brocade-snmp namespace.

2. Under the node, include the node element.

3. Under the node, include the following leaf element.

a. In the element, specify the IPv4, IPv6, or DNS address of the SNMP host.

b. In the element, specify the name of the user to be associated with the SNMP

server host.

This user name must already be defined in the / node.

c. Optionally, in the element, specify the UDP port where SNMP traps will be

received.

The default value is 162.

d. Optionally, in the element, specify “informs” or “traps” depending on whether

informs or traps are to be sent to the host.

The default value is “traps”.

e. Optionally, in the element, specify the remote engine ID to receive informs on

the host.

The default value is 00:00:00:00:00:00:00:00:00.

f.

Optionally, in the field, specify the level of trap to be associated with SNMP
traps.

The following example configures dns1.mycorp.com as an SNMPv3 host and associates the
snmpuser3 version 3 user with it. In this case, a DNS address is used to identify the server.