beautypg.com

Configuring switched port analyzer, In this chapter, Span configuration with netconf overview – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 527: Chapter 32, Chapter 32, “configuring switched port analyzer

background image

Network OS NETCONF Operations Guide

495

53-1003231-02

Chapter

32

Configuring Switched Port Analyzer

In this chapter

SPAN configuration with NETCONF overview. . . . . . . . . . . . . . . . . . . . . . . . 495

Configuring ingress SPAN, egress SPAN, or bidirectional SPAN. . . . . . . . . 495

Deleting a SPAN connection from a session . . . . . . . . . . . . . . . . . . . . . . . . 497

Deleting a SPAN session . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 498

SPAN in management cluster . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 499

Configuring RSPAN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500

SPAN configuration with NETCONF overview

This chapter provides procedures for configuring Switched Port Analyzer (SPAN) monitoring
sessions using the NETCONF interface. Refer to the Network OS Administrator’s Guide for the
following related information:

A conceptual overview of SPAN

General guidelines for using SPAN

Procedures for configuring SPAN using the Network OS command line interface (CLI)

Conceptual overview of RSPAN

General guidelines for using RSPAN

Using the NETCONF interface, you can perform the following SPAN configuration operations:

Use the remote procedure call (RPC) to configure SPAN.

Use the RPC to verify all or part of the SPAN configuration.

SPAN parameters are defined in the brocade-span YANG module. For a structural map of the YANG
module, refer to the Network OS YANG Reference Manual. For definitions and explanations of all
SPAN parameters, refer to the brocade-span.yang file.

Configuring ingress SPAN, egress SPAN, or bidirectional SPAN

Repeat the following procedure for each source port you want to monitor. A monitor session can
have only one source port. For additional ports you must create additional monitor sessions.

To configure SPAN, perform the following steps.