Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 565)

Network OS NETCONF Operations Guide 533
53-1003231-02
Chapter
35
Configuring VRRP
In this chapter
• VRRP and VRRP-E configuration with NETCONF overview . . . . . . . . . . . . . 533
• VRRP basic configuration example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 535
• Enabling preemption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 539
• Configuring the track priority . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 541
• Enabling short-path forwarding (VRRP-E only). . . . . . . . . . . . . . . . . . . . . . . 544
• Configuring a multigroup virtual router cluster . . . . . . . . . . . . . . . . . . . . . . 545
• Verifying VRRP and VRRP-E configuration . . . . . . . . . . . . . . . . . . . . . . . . . . 551
VRRP and VRRP-E configuration with NETCONF overview
This chapter provides procedures for configuring the Virtual Router Redundancy Protocol (VRRP)
using the NETCONF interface. Refer to the Network OS Administrator’s Guide for the following
related information:
• A conceptual overview of VRRP
• General guidelines
• An overview of VRRP and VRRP-E packet behavior
• Procedures for configuring VRRP using the command line interface
Through the NETCONF interface, you can perform the following operations on VRRP and VRRP-E:
• Use the RPC to configure VRRP and VRRP-E.
• Use the RPC to validate configuration settings.
VRRP parameters are defined in the brocade-vrrp YANG module. For details, refer to the Network
OS YANG Reference Manual.