Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 306)

274 Network OS NETCONF Operations Guide
53-1003231-02
Configuring FCoE interfaces
20
To assign an FCoE map to a LAG, perform the following steps.
1. Issue the RPC to configure the / node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, in the leaf element, specify the port-channel number
of the LAG to which you want to apply the FCoE map.
3. Under the node, specify the node in the
urn:brocade.com:mgmt:brocade-fcoe namespace.
4. Under the node, specify the leaf element, and set its value to
“default”.
The following example applies the default FCoE map to port channel 5.
5
default
5. Confirm the changes to the interface using the RPC with a subtree filter to return
only the node information for a specific port channel.
The output returns the FCoE mapping association for the interface.
5