Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 55)

Network OS NETCONF Operations Guide 23
53-1003231-02
Chapter
3
Basic Switch Management
In this chapter
• Basic switch management with NETCONF overview . . . . . . . . . . . . . . . . . . . 23
• Connecting to the switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
• Switch attributes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
• Disabling or enabling a chassis . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
• Rebooting a Brocade switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
• Interfaces, slots, and modules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
• Configuring a switch banner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
• supportSave data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
• Syslog server setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
• RASlog configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
• Audit log configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
Basic switch management with NETCONF overview
This chapter provides procedures for performing some basic switch operations using the NETCONF
interface.
Refer to the Network OS Administrator’s Guide for the following related information:
• Conceptual and overview information
• Using DHCP Automatic Deployment (DAD)
• Procedures for configuring the Ethernet management interface
• Basic switch configuration using the Network OS command line interface (CLI)
Using the NETCONF interface, you can perform the following basic switch configuration operations
described in this chapter:
• Use the RPC to set host attributes, configure a line card type on a chassis slot,
configure a switch banner, enable or disable first failure data capture (FFDC), and configure
logging.
• Use custom actions to enable or disable a chassis, reboot a switch, power on/off a line card,
obtain slot and module status, and upload supportSave data.
• Use the custom RPC to return RASlog messages.
Switch management parameters described in this chapter are defined mostly in the brocade-ras,
brocade-linecard-management, and brocade-chassis YANG modules. For structural maps of these
YANG modules, refer to the Network OS YANG Reference Manual. For definitions and explanations
of parameters, refer to the corresponding .yang file.