Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 488)

456 Network OS NETCONF Operations Guide
53-1003231-02
Data Center Bridging map configuration
29
The following example creates a CEE map named “default.”
default
Defining a priority group table
To define a priority group table, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-cee-map namespace.
2. Under the node, include the element and set its value to “default,” which
is the name of the CEE map.
3. Under the node, include the node once for each priority
group ID (PGID).
4. Under each node, include the PGID, configure the bandwidth for the
priority group by associating a weight with a DWRR scheduler queue, and enable priority-based
flow control (PFC).
5. Issue the RPC to save the running-config file to the startup-config file.
The following example defines two priority groups, assigns 50% bandwidth to each, enables PFC for
the first priority group, and disables PFC for the second priority group.
default
0
50
on
1
50
off