Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 510)

478 Network OS NETCONF Operations Guide
53-1003231-02
Interface-specific administrative tasks for 802.1x
30
3. Under the , , , or
node, include the leaf element and specify the name of
the interface on which you want to configure 802.1x authentication timers. Specify the
interface in [rbridge-id/]slot/port format.
4. Under the , , , or
node, include the node element from the
urn:brocade.com:mgmt:brocade-dot1x namespace.
5. Under the node, include the node element.
6. Under the node, include the , , , or
leaf element and specify a new timeout value.
7. Issue the RPC to save the running-config file to the startup-config file.
The following example changes the supplicant timeout value to 40 seconds.
22/0/1
40
Configuring 802.1x re-authentication on interface ports
To configure 802.1x port re-authentication on a specific interface port, perform the following steps.
Repeat this task for each interface port you wish to modify.
The default re-authentication period is 3600 seconds.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, specify the , ,
, or node element.
NOTE
You cannot configure 802.1x authentication on a port-channel.