beautypg.com

Configuring ipv4 unicast address family – Brocade Network OS NETCONF Operations Guide v4.1.1 User Manual

Page 592

background image

560

Network OS NETCONF Operations Guide

53-1003231-02

Configuring BGP

37

188

default

1.1.1.1

20

xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

Configuring IPv4 unicast address family

Currently only the IPv4 unicast address family is supported.

The following configurations are allowed under BGP IPv4 address-family mode:

Network (including static networks)

Route aggregation

Route redistribution

Route reflection

Dampening

Default route origination

Multipathing (including maximum paths)

Address-family-specific neighbor configuration

Explicit specification of networks to advertise

Nodes that are specific to address-family configuration are:

aggregate-address—Configure BGP aggregate entries

always-propagate—Allow readvertisement of best BGP routes not in IP Forwarding table

bgp-redistribute-internal—Allow redistribution of iBGP routes into IGPs

client-to-client-reflection—Configure client to client route reflection

dampening—Enable route-flap dampening

default-information-originate—Originate Default Information