Snmp requirements – Carrier Access Access Navigator User Manual
Page 666
C-8
August 2003
Access Navigator - Release 1.8
SNMP Interface
SNMP Requirements
SNMP Requirements
CLI commands must be used to configure the Access Navigator for SNMP operation. In particular, the
operator must set up the Ethernet port, SNMP community strings, and NMS IP addresses. (See CLI
Language Reference on
.) SNMP configuration includes the following items.
NOTE:
To provide secure access, community strings are required for SNMP
management, but can not be changed or displayed using SNMP set and get commands.
Access attempts using invalid community names will be trapped and reported to the NMS.
* Contact and location can be changed through objects in the standard SNMP System Group.
† NMS IP addresses can be changed through objects in the Carrier Access Enterprise MIB.
Table C-3 SNMP Configuration Items
Commands
Descriptions
set ethernet ip address
Ethernet IP address and mask
set ip gateway
Gateway IP address
set snmp contact
System contact *
set snmp location
System location *
set snmp getcom
Get community
set snmp setcom
Set community
set snmp trapcom
Trap community
set snmp nms
NMS IP address (up to 3) †