Carrier Access Access Navigator - Manual (Page 108)

6-4 August 2003 Access Navigator - Release 1.8
Electrical Installation
Tools and Materials Required
7. Always store circuit cards in an anti-static storage bag. Whenever possible, use the same storage bag
the card or replacement card came in.
8. If a circuit card is to be returned to the factory, always ship the circuit card inside an anti-static storage
bag.
Tools and Materials Required
Electrical installation requires the following tools and materials.
• Screwdrivers, Phillips #2 and #3
• Screwdrivers, slotted
• Pliers, needle nose
• Cutters, diagonal
• Wire stripper, 16-26 AWG
• Wire wrap tool, bits for 22, 24, 26 AWG
• Wire unwrap tool
• Wire ties
• Grounding wrist strap
• Continuity tester
• Volt-ohm meter
• Shielded RS-232 cable: DTE-to-DCE for direct connection to a computer or a DCE-to-DCE
(null modem cable) for connection to a modem (see RS-232 Management Connection on
page 6-17 )
• Shielded DSX-1 cables (2 ea.), PN 005-0025 (10 ft.) or 005-0030 (25 ft.), or equivalent
NOTE: ABAM shielded cable is recommended for extending DSX-1 connections.