Carrier Access Access Navigator - Manual (Page 310)

13-14 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via IP DS0
Provision Groom DS1s to Adit Router
NOTE:
When loop code detection is turned on, the Access Navigator will respond to
T1.403 ESF bit patterned loop requests. Loop detection is normally turned off for DS1
drops.
9. Set drop DS1 loop request code detection off with the following command:
set ds1 loopdetect off
Example: set ds1 32 loopdetect off
10. Set DS1 identification
set ds1 id <"name">
Example: set ds1 32 id "DS1#32"
11. Set DS1 in service
set ds1 up
Example: set ds1 32 up