Carrier Access Access Navigator - Manual (Page 301)

Access Navigator - Release 1.8 August 2003 13-5
Provision Remote Adit 600 via IP DS0
Router Provisioning Quick Guide
Router Provisioning Quick Guide
NOTE: The following commands assume that the Router card is in slot 1.
NOTE: The remote Adit WAN address MUST have a different subnet than the Adit
Controller address.
set ds0 up Set DS0s in service.
set ds1 up Set DS1s in service.
status remote Verify status of management channel.
Adit CLI Commands Descriptions
set local off Sets Adit to be configured through
CLI.
set a:2 down Sets T1-2 out of service.
disconnect a Disconnects all connections to slot a
(controller).
set a:1:24 type data Sets all DS0s on T1-1 to data
signalling type.
connect a:1:1 1:1:1
connect a:1:2 1:1:2
connect a:1:24 1:1:24
Connects DS0s on controller T1-1 to
DS0s of port 1, WAN 1 to 24, of
Router in slot 1.
Repeat for all 24 channels.
Router Setup
Telnet into Router by specifying {slot}:{port}.
Example: telnet 1:1
Enter password (default is "admin") and press Enter key.
Note: Once you are in the Router, the Tab key will move you through the menus and the Spacebar
will scroll you through selections in <>.
Select Terminal Emulation (scroll with Tab key) and press Enter key.
Access Navigator CLI Commands Descriptions