Carrier Access Access Navigator - Manual (Page 578)

18-122 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Set Remote T1Drop Framing
CAUTION! I F THE T1 D ROP ON THE A CCESS B ANK II WILL BE USED , THE T1 D ROP
CIRCUIT OR LOOPBACK MUST BE INSTALLED BEFORE DOWNLOADING THE
CONFIGURATION , OTHERWISE THE RESULTING AIS ALARM WILL TAKE DOWN THE FDL
COMMUNICATIONS LINK UNTIL THE CIRCUIT IS INSTALLED AND THE ALARM CLEARED
Purpose: Sets the T1 Drop framing type to D4 or ESF. (T1 PBXs generally use D4 framing; T1
routers may use D4 or ESF.)
The Access Bank II provides a second T1 port, called the T1 Drop, for connection to a
T1 PBX or T1 router. You can connect one or more DS0s to the T1 Drop, using a
fractional interface. The Access Navigator automatically assigns DS0s to the T1 drop
in sequential order, starting with T1 Drop DS0 #1. If the router does not have automatic
rate sensing, it will have to be programmed for the proper data rate. Use the show
remote
command to display the current settings stored in the Access Navigator’s data
base).
Security: Level 2 (operator)
Syntax: set remote <n> t1drop framing <d4|esf>
Example: set remote 9 t1drop framing d4
Field Description
n DS1 number, 1 to 32.
d4 Set T1 Drop to D4 framing.
esf Set T1 Drop to ESF framing.