Show crv, Show crv -136 – Carrier Access Access Navigator User Manual
Page 593
Access Navigator - Release 1.8
August 2003
18-137
CLI Language Reference
CLI Command List
Show CRV
Purpose:
Displays the range of CRVs requested (up to 24), along with the DS1 and DS0 channel
to which they are currently assigned.
Factory default CRVs are sequentially numbered from 1 to 768, starting with the first
DS0 channel on DS1 #1 and continuing to the last DS0 channel on DS1 #32. See Figure
18-30 on
If desired, the user can assign different CRV numbers. (See Set DS0 CRV on
.) The only requirement is that the CRVs for all assigned GR-303 or TR-08
voice terminations must be different.
NOTE:
In the following command, there can be up to 24 CRVs in a range,
such as 1-24 or 110-134. The CRVs do not have to be on the same DS1.
Security:
Level 3 (monitor)
Syntax:
show crv <range>
Example:
show crv 6
Example:
show crv 1-8
Message:
CRV Interface Status
--- --------- ------
1 DS1 #1 channel 1 In Service
2 DS1 #1 channel 2 In Service
.....
Indicates no current connection to another DS0 in the Access
Navigator. (GR-303 connections are dynamic and will be
displayed when calls are connected.)
Type
VOICE – voice channel
DATA – data channel
GR303 – GR-303 voice channel or ISDN BRI 4:1 TDM
EOC-P – EOC primary channel
EOC-S – EOC secondary channel
TMC-P – TMC primary channel
TMC-S – TMC secondary channel
Interface
Name of fractional interface, if any, using "From" DS0.
[-->
Port]
Remote interface port, if any, connected to fractional interface.
Field
Description
range
Call Reference Value, 1 to 768, or a range of values such as 15-
18. Maximum range is 24 CRVs.
Item
Description