Carrier Access Access Navigator User Manual

Access navigator

Access Navigator

SER

ANUAL

Part Number: 770-0079-AP

Product Release: 1.8

August 2003

Table of contents

Document Outline

Title Page
Preface
- Compliance
- Notices
- Electrostatic Discharge (ESD) Precautions
- Carrier Access Software License Agreement
- Warranty
  - Limitations of Warranty & Limitation of Remedies
  - Warranty Product Returns
Table of Contents
1. Introduction
- Overview
- Features and Benefits
- Access Navigator Configurations
- System Architecture
- Carrier Access Support Products
  - Access Banks
  - Adit 600
- Management
2. Access Navigator / DCS Service Manager
- Overview
- System Architecture
- Features and Benefits
- Configuration
- Applications
- Interfaces
- Specifications
- Compliance Requirements
- Ordering Information
3. Access Navigator / GR-303 + Data Host
- Overview
- System Architecture
- Features and Benefits
- GR-303 Services
- DCS Services
- Management Architecture
  - IP DS0 Management
  - FDL Management
- Configuration
- Applications
- Interfaces
- Specifications
- Compliance Requirements
- Ordering Information
4. Access Navigator / GR-303 Host with P-Phone
- Overview
- System Architecture
- Features and Benefits
- GR-303 Services
- P-Phone Services
- DCS Services
- Management Architecture
  - IP DS0 Management
  - FDL Management
- Configuration
- Applications
- Interfaces
- Specifications
- Compliance Requirements
- Ordering Information
5. Physical Installation
- Compliance and Safety Requirements
- Tools and Materials
- Unpacking and Inspection
- Horizontal 19-Inch Rack Mount
- Horizontal 23-Inch Rack Mount
- Vertical Rack Mount Using Crossbars
- Vertical Wall Mount
6. Electrical Installation
- Compliance and Safety Requirements
- Static-Sensitive Equipment Handling Procedures
- Tools and Materials Required
- Chassis Ground Connection
- DSX-1 Cable Connections
- RS-232 Management Connection
- Ethernet Management Connection
- External Timing Source (BITS) Connection
- Alarm Output Connections
- Alarm Input Connections
- DC Power Connections
- Dress Cables and Wires
- Acceptance Test
- Install Redundant Controller Card
- Install Additional Quad T1 Framer Cards
- Configure Management Interfaces
7. Start Management Session
- Management Requirements
- Command Line Interface Conventions
- RS-232 Management
- Telnet Management
- NetworkValet EMS and Valet Management
8. Provision Access Navigator
- Basic Provisioning Overview
- Basic Provisioning Quick Guide
- Obtain Provisioning Information
- Verify System Equipment Configuration
- Set System ID or CLLI Code
- Set Date
- Set Time
- Set Ethernet Properties
- Set User and Password Security
- Set SNMP Properties
9. Provision DCS Service
- DCS Provisioning Overview
  - Provisioning ISDN BRI Service
  - Provisioning TR-08 Service with DCS
- DCS Provisioning Quick Guide
- Obtain Provisioning Information
- Verify System Equipment Configuration
- Verify Service Status
- Set Unused Circuits Out of Service
- Set System Clock Source
- Provision “Groom” DS1 Circuits to Network
- Test Groom DS1 Circuits
- Provision “Drop” DS1 Circuits to Subscribers
- Provision and Connect ISDN PRI Channels
- Provision and Connect ISDN BRI 3DS0 Channels
- Provision and Connect DS0s
- Turn Up Service
- Test DS1 and DS0 Circuits
10. Provision GR-303 Service
- GR-303 Provisioning Overview
- GR-303 Provisioning Quick Guide
- Obtain Provisioning Information
- Verify System Equipment Configuration
- Verify Service Status
- Set Unused Circuits Out of Service
- Set System Switch Type
- Set System Clock Source
- Provision “Switch” DS1s to Interface Group
- Assign Primary and Secondary EOC
- Assign Primary and Secondary TMC
- Test DS1 Circuits
- Provision “Drop” DS1 Circuits to Subscriber
- Provision ISDN BRI 4:1 TDM Service to Subscribers
- Provision DS0s to Subscribers
- Assign Call Reference Values (CRVs)
- Turn Up Service
- Test Circuits
11. Provision Remote Access Bank II
- Remote Access Bank II Provisioning Overview
- Remote Access Bank II Provisioning Quick Guide
- Remote Access Bank II Maintenance Quick Guide
- Obtain Provisioning Information
- Verify System Equipment Configuration
- Temporarily Disable Configuration Downloading
- Provision Drop DS1 to Remote Access Bank II
- Test DS1 Circuits
- Provision DS0s
- Provision DS0 Crossconnects
- Create Fractional Interfaces (if required)
- Configure Remote RS-232 Interface (if used)
- Configure Remote T1 Drop Interface (if used)
- Configure Remote V.35 Interface (if used)
- Connect Fractional Interface to Remote Interface
- Download Configuration to Remote Access Bank II
- Verify Downloaded Settings (optional)
- Turn Up Service
- Test Remote Circuits
12. Provision Remote Adit 600 via FDL
- Remote Adit 600 FDL Provisioning Overview
  - FDL Management Configuration
- Remote Adit 600 FDL Provisioning Quick Guide
- Obtain Provisioning Information
- Verify Equipment Configuration
- Provision Drop DS1s to Remote Adit 600
- Provision Drop DS0s
- Provision DS0 Crossconnects (if required)
- Provision Remote Adit 600
- Test DS1 and DS0 Circuits
13. Provision Remote Adit 600 via IP DS0
- Remote IP DS0 Provisioning Overview
  - IP DS0 Management Configuration
- Remote IP DS0 Provisioning Quick Guide
- Router Provisioning Quick Guide
- Remote Adit IP DS0 Provisioning Quick Guide
- Obtain Provisioning Information
- Verify Equipment Configuration
- Provision Groom DS1s to Adit Router
- Provision Drop DS1s to Remote Adit
- Provision Groom DS0s to Adit Router
- Provision Drop DS0s to Remote Adit
- Provision DS0 Crossconnects
- Provision Remote Adit 600
- Test DS1 and DS0 Circuits
14. Alarm Clearing
- Identify Alarm Clearing Procedure
- Clear Alarms - FDL
- Clear Alarms - EOC
- Clear Alarms - SNMP
- Clear Alarms - Status Indicators
15. Diagnostics & Troubleshooting
- Alarms and Logs
- Alarm and Status Indicators
  - Indicator Locations
  - Indicator Descriptions
- Status and Performance
- GR-303 Status and Performance
- Near-End Loopbacks
- Far-End Loopbacks
- Access Bank II Loopbacks
- Bit Patterns and Error Tests
- Other Maintenance Commands
- Technical Support
16. Maintenance Procedures
- Compliance and Safety Requirements
- Repair and Return Procedure
- Replace Controller Card
- Replace Quad T1 Framer Card
- Install SIMM on Controller Card
17. Update Controller Card Software
- Overview
  - Download Procedures
- Update Software via TFTP (Two Controllers)
- Update Software via Xmodem (Two Controllers)
- Update Software via Xmodem (One Controller)
18. CLI Language Reference
- Overview
- CLI Requirements
- CLI Conventions and Shortcuts
- Online Help
- Users and Passwords
- Logging In and Out
- CLI Command List
A. EOC Interface
- Overview
- Managed Object Class Support
- Actions
- Notifications
B. FDL Interface
- Overview
- Remote Provisioning Requirements
- Remote Provisioning Capabilities
  - Access Bank II Capabilities
C. SNMP Interface
- Overview
- Carrier Access Enterprise MIB
- SNMP Basics
- SNMP Trap Reports
Glossary
- Abbreviations/Acronyms
- Definitions
Index