Carrier Access Access Navigator User Manual
Page 238
10-24
August 2003
Access Navigator - Release 1.8
Provision GR-303 Service
Provision “Drop” DS1 Circuits to Subscriber
NOTE:
Remote Access Bank II provisioning requires “esf” framing and remote device
management for “cafdl” protocol. See Provision Remote Access Bank II on
Remote Adit 600 provisioning requires remote device management protocol for "cafdl" or
"caip" depending on management configuration. P-Phone service is enabled by "caip" with
the "pphone" option. There can be only one management DS1 to a remote Adit 600, so all
other DS1s to that Adit 600 must be set to point to the management DS1. See Provision
Remote Adit 600 via FDL on
and Provision Remote Adit 600 via IP DS0 on
.
11. Set drop DS1 remote device management protocol to none, Carrier Access FDL, Carrier Access IP,
or a DS1 with the following command:
set ds1
<none|cafdl|caip <ipaddress>|ds1 n> [pphone]
Example:
set ds1 9 remote device mgmt none
Example:
set ds1 9 remote device mgmt cafdl
Example:
set ds1 9 remote device mgmt caip 192.168.201.1
Example:
set ds1 9 remote device mgmt caip 192.168.201.1 pphone
Example:
set ds1 9 remote device mgmt ds1 10