Carrier Access Access Navigator - Manual (Page 626)

18-170 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Status IP
Purpose: The Ethernet port on the Access Navigator provides an Internet Protocol (IP) interface.
Currently, the show ip and status ip commands produce the same message,
listing the IP address and subnet mask, and the gateway address.
Security: Level 3 (monitor)
Syntax: show ip
Message:
IP Address and Mask: 192.168.3.158 255.255.255.0
IP Address of the Gateway: 192.168.3.202
Description:
Field Description
IP Address Each Access Navigator on the same Ethernet network must have
a unique static Internet Protocol (IP) address. IP addresses have
the format xxx.xxx.xxx.xxx, where each xxx is a decimal
number between 0 and 255. For example, 192.168.0.123 is a
valid IP address. Note that the address contains only three
periods, one between each of the four numbers. If the Ethernet
interface is not used, type
none for the IP address.
IP Mask The Access Navigator uses a subnet mask to identify the
permissible range of addresses for each IP address. Large
networks are usually divided into smaller subnetworks, each with
an assigned range of IP addresses. Subnet masks have the format
xxx.xxx.xxx.xxx
, where each xxx is a decimal number
between 0 and 255. Subnet masks usually start with one or more
groups of 255. Typical examples include 255.255.0.0 and
255.255.255.0
. If a subnet mask is not used, the field will be
blank.
IP Address of Gateway Gateway addresses have the format xxx.xxx.xxx.xxx,
where each xxx is a decimal number between 0 and 255. If a
gateway address is not used, the value is none.