Carrier Access Access Navigator - Manual (Page 311)

Access Navigator - Release 1.8 August 2003 13-15
Provision Remote Adit 600 via IP DS0
Provision Drop DS1s to Remote Adit
Provision Drop DS1s to Remote Adit
1. Show drop DS1 settings with the following command:
show ds1
Example: show ds1 10
The show command will produce a message showing the DS1 settings. For example, the message
for DS1 number 1 might look similar to the following:
Settings for DS1 32:
Circuit ID: CA DS1# 32
Up/Down: UP
Framing: ESF
Line Coding: B8ZS
Type: DROP
Clock Source: NORMAL
Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection: OFF
Loop Back: OFF
Line Termination ID: 0 (for switch DS1s only)
Remote Device MGMT: CA IP CA 192.168.201.1
PPHONE Call Connection: Enabled
FDL Type: None
Send Code: OFF
Performance Thresholds: 15 min. 1 hour 1 day
-------- -------- --------
unavailable seconds: 0 0 0
severely errored seconds: 0 0 0
errored seconds: 0 0 0
sev. errored frame seconds: 0 0 0
degraded minutes: 0 0 0
linecode violations: 0 0 0
2. If drop DS1 settings are correct, skip remaining steps.